Hello Sergey!
I could not configure the EDUP KW-AC6018 repeater, this is a Chinese dual-band repeater that can also work as an access point.
In any mode, two more new networks are created, and it does not matter what they are called - all the same, these are other networks, and not an extension of the old ones.
I am sending a manual for this device. My main SERCOM RV6699 router has the same address as EDUP KW-AC6018 192,168,1,254.
I change it to 192,168,1,101 on the repeater, tune in to expandable networks with the indication of passwords, I set the channels like the old ones. in the status everything is ok. And there is no Internet either in repeater mode or in access point mode.
I was confused by the DHCP settings on the repeater regarding DNS servers, I tried different combinations - single-member.
Maybe you can tell me.
Alexey.
Answer
Hello. I would have had this EDUP KW-AC6018. And so there is no way to check and see what is there with the settings.
The standard Wi-Fi network (or networks) will remain until the peeter is configured to connect to your network. Then these networks disappear.
Judging by the photo with the instructions, there is a setup wizard. Where you can configure everything step by step. In addition, the control panel is in English (not Chinese). And this is already good 🙂
Reset the EDUP KW-AC6018 parameters and without changing any settings try to configure it through the quick setup wizard. If you do not have access to the Internet again, then try setting it up with a different Wi-Fi network. Maybe your router for some reason does not give it the Internet.
Or, after factory reset, try configuring it via the WPS button. By activating WPS on your router, and pressing the corresponding button on the EDUP KW-AC6018 repeater. The connection may be established automatically.
Unfortunately this is all I can advise in this situation.
25.11.17
11
Asked by Alexey
