ZyXEL Keenetic Start II and ADSL modem. How to setup?

Pin
Send
Share
Send

Hello. Router ZyXEL Keenetic Start 2.

I tried to install a new router. I connected it to the modem through the blue wire, and connected the router itself to the laptop through the second, yellow wire.

In the quick setup of NetFriend, I could not get everything right, because the contract with the provider was lost. I was looking for an ip, gateway, etc. in a laptop, entered it in the settings, but still at the end of the setup it came out "the setup is complete, but the Internet connection failed."

Then the employee of the TTK service tried to help me, he said that it is better to use not the quick setup, but the web configurator. There I did everything as he said. Eventually
The Internet works on the laptop. Wi-Fi is not. (I tried to use Wi-Fi on the iPad, all to no avail).

The Internet indicator on the router is off.

What do you recommend to do? How to get Wi-Fi to work?

Answer

Hello. You needed to describe the connection diagram in detail. What modem? And most importantly, does the Internet from the modem work (when you just plug the cable into the laptop)? Without starting any connections on the computer. If the modem is configured correctly, and the Internet works from it, then there should be no problems with setting up ZyXEL Keenetic Start at all.

Reset your ZyXEL router first.

Just connect the cable from the modem to the blue WAN port of the router (most likely it is signed as the Internet). And the Internet through the router should already work. Including Wi-Fi.

But you can go into the settings and go through the setup through the quick setup wizard (NetFriend). Only during the configuration process, in the "IP Protocol Settings" section, in the "IP Address Settings" menu, select "Automatic". As in the instructions for setting up ZyXEL Keenetic Start. You do not need to set any static addresses, etc. However, if the ADSL modem is configured correctly and distributes IP automatically.

When the Internet via ZyXEL Keenetic Start 2 works, you can set up a Wi-Fi network. In the instructions on the link above, I wrote about this.

15.10.17

0

Asked by Tatiana

Pin
Send
Share
Send

Watch the video: настройка Zyxel Keenetic Start (May 2024).

essaisrff-com